Stain & Finishing Oil is a wood conditioner, stain, and top coat all in one that offers exceptional durability in high-traffic areas like table tops, kitchen cabinets, and even flooring.
It can be used on bare wood or over previously painted surfaces. No additional top coat is required – it is highly durable as is. If you’re looking for added durability, applying a coat of Natural will increase sheen and durability without intensifying your colour.
If you apply it over Fusion Mineral Paint™ for a glaze effect or to increase the sheen, we recommend removing excess immediately, as the SFO will not soak in and may leave a sticky finish that takes a few days to dry.
Use the Natural colour over Fusion Mineral Paint™ colours to increase the sheen and offer superior durability, or brush on one of the pigmented colours and wipe off immediately for a beautiful, easy glaze effect.
Our special blend is highly concentrated in pigment, so a little goes a long way. The 237 mL container will cover the same area as 1 litre of comparable stains.
Please keep in mind that all oil-based products typically yellow in time. Using this over top of white paints will cause a slight yellowing effect. We recommend our Tough Coat for going over lighter colours to avoid yellowing.
Our Stain & Finishing Oil is composed of plant products, Safflower oil, Tung oil, Linseed oil, Vegetable wax, safe odorless mineral solvent and cobalt free siccative which means effective drying without toxic cobalt dryers while being virtually odorless.
|Brush, lint free rag, applicator pad
|No additional top coat is required.- this is made strong enough for floors and table tops. However you may use wax or “Natural” colour Stain & Finishing Oil to increase the sheen but not deepen the colour.
|Odourless Mineral Spirit
|3,5 - 6,9m² The 237 mL container will cover the same area as 1 litre of comparable stains.
|Matte to high sheen. Each additional layer and buffing increases the sheen.
|Reclaimed wood, bare wood, table tops, floors, most any surface, painted finish or Milk Painted pieces.
|Can Be Applied To
|Use as a stain over raw or well-sanded wood; apply over painted surface for added sheen, glaze effect, or added protection; seal milk paint or other porous paint. Not recommended over light colours as it will yellow.
|Can Be Painted Over
|Yes, once dried if over bare wood and only 1 coat applied, 10 days after for multiple coats applied . Test to ensure prior to tackling a full project.
|How to Prep
|Apply over any surface or top coat for desired effect except wax.
|Light cleaners, as they will strip away the natural oil.